The second network is going to be the users in the WIFI, which as I understood, will be VLAN28. Management network is the network in which you will access the TL-SG108E GUI page to configure it, so, this is only used for management, nothing else, this will be VLAN1. Yes, put the TL-AX6600 in bridge mode, and connect the cable coming from the TL-SG108E in a LAN port, do not use the WAN port.įirst problem I see is you used the VLAN28 address range for MGMT. If that works, we will proceed with the next steps. Lastly, try to ping the switch from pfsense, login in pfsense and ping 172.16.0.2 and come back here to confirm if its working. Then, in the switch, you configure that port that is connected to pfsense, to PVID1 and VLAN1 untagged. Then, go to your switch TL-SG108E, and put an IP address of 172.16.0.2 / 24 in it. We are not creating a VLAN yet ok? Go to Interfaces tab, select Igb2 interface, tick enable, then add a static IP address in it, lets say something like: 172.16.0.1 / 24.
In this step, you should add an IP address to Igb2 interface itself, this will be the gateway for the management network. Well, lets do it in steps first ok? First lets do the management part, which will allow you to be able to ping the switches from pfsense.ġ - Pfsense should have IP address in the Igb2 interface. Still today, sometimes I find myself being a newbie, still learning every day. No need to say sorry, I was newbie once too. Said in TP-LINK TL-SG108E VLAN configuration issue:ĭoes it look like I followed the correct steps?
0 kommentar(er)
